If you looking to rotate make review any product for the public by Display Stand a present, you may think of purchasing from the market which can be costed and sometimes high prices. So if you make it at home at a low cost why don't this?
Here I share how to make this one...
Materials Required
- One round of any plastic box around 6-8-10 inch like
- Gear Motor-6-12 Volt-500RPM
- ON/Off Switch
- Speed Controller
- DC jack 12V
- 18650 battery case
- 18650 2 battery
- Some accessories Materials
 |
| Plastic Round box |
 |
Gear Motor-6-12 Volt-500RPM |
 |
| On Off Switch |
 |
Speed Controller |
 |
DC Jack |
 |
18650 Battry Case |
 |
18650 2 Battery |
After avail all supported materials now you can start to make
The process to make Display Stand Make At Home :
First process the plastic box-hole center for the motor set, and in the cover also set for motor movement- details see on video.
Set the gear motor on the box and now set all of the parts in the box like speed control, battery case, and DC jack. All of the components are joined as the diagram and video shown just follow to make this.
On the cover that is moving on the motor, it should be properly centralized for the smooth movement that is shown.
After all sets of components are properly now you can check for movement.
After all, is ok you can color outside enamel paint for better looks. That's it.
Follow the Facebook page to see any updated tech-related information.
Subscribe YouTube channel
See full details in Video.